And in some other cases the unifi switch just won t reset the factory mode with the button alone.
Unifi switch 48 factory reset.
Unifi tech support says its possible but i have tried at least 5 times with no success any of those times.
The quick start guide qsg for each model displays the location of the reset button and provides more information on the reset process.
Switch with sfp models.
Unifi devices can also be reset to factory defaults using physical reset button.
Ifconfig eth0 ip netmask mask route add net default gw ip.
The unifi switch itself should be housed inside a protective enclosure.
Further i ve read a few other accounts of people having this same problem with this exact.
The unifi switch offers the forwarding capacity to simultaneously process traffic on all ports at line rate without any packet loss.
But yes normally the reset button will work most of the time.
Restore to factory default settings press and hold the reset button.
To reset the ap the factory settings you will need to hold the button for at least 5 seconds.
The reset button has two functions on the unifi access point.
Restart press and release the reset button quickly.
Us 48 500w us 48 750w power cord mounting screws 10 32 x 5 8 qty.
Either open up that port or turn off the firewall if that s a possibility.
If you press and release the button quickly then the access point will only restart.
See what ports are needed for unifi here.
For its total non blocking throughput the 24 port model supports up to 26 gbps while the 48 port model supports up to 70 gbps.
Following these steps will help to fix those issues.
But if you have a poe device connected to an unifi switch it won t factory reset.
Currently i have tried the following.
Has anyone ever been able to factory reset a unifi switch 8 poe 60w using the reset button.
There is also an option to reset the unifi access point remotely if you are using the unifi gigabit poe.
Factory reset 48 port unifi switch trying to register it against an aws cloud controller.
The location of the reset button will differ depending on the unifi model that you are using.
I m trying to set it from the default ip of 192 168 1 20 to something that would match my local network and also set a route so it can then communicate out.
